right right but not the whole answer rear wing of what? new clues its a full car for the wing but what car? see in one of my other forum posts for what it is the aluminium is an upgraded main part, see in one of my other forum posts for what it is |
|
Please Log in to join the conversation.
Last edit: by zephyrin.
|
2 photos
just done on my phone those brown flecks are mud, i ran it a few times today parts it has from the warhead jeep thing: wheels/tires spur gear shocks battery motor esc receiver things i have done to it removed the droop screws to get a few more mm's in ride height put the original cooling on brushless, why not? removed the horrible looking fake spare tire and put an actual one on the back replaced the plastic spur with the metal one out of the warhead swapped the too long plastic shocks with great fitting metal shocks kept the servo, its surprisingly good put in my orange receiver because the original gun transmitter was glitching a little bit put my good tires on it the bad things when you first buy the buggy shocks motor esc transmitter battery spur the good things when you first buy the buggy everything besides the above my good parts from the warhead fit perfectly the servo is fast and strong, it says waterproof but i don't really trust the sticker, no point in waterproofing it if its the only thing, my esc, receiver, motor, battery can't get wet |
|
Please Log in to join the conversation.
Last edit: by zephyrin.
|
yeah it is
i'm thinking of doing a monster energy based paint job on it, not sure what the best way to remove the paint it, i think it might be printed on. any sugestions? the motor runs cooler than on the warhead and its quieter it reminds me of an axial EXO, but without the 16 screws to get to the esc it has too much power for wet roads if it is dry then it wheelies on command |
|
Please Log in to join the conversation.
Last edit: by zephyrin.
|
|
looks great might pick one up myself at that price its a bargain
|
Please Log in to join the conversation. |
Bashed my car at the port macquarie skate park
Results: 2 bent drive shafts 1 bent shock shaft, i swapped my metal shocks for the stock plastic because the oil is thicker and better for jumps 2 stripped screw holes for the front bumper 1 bent body clip Esc fell out A screw for the roof popped through 1 broke a piece of the chassis off, not structual though When i broke the chassis i found out that it is FRP wooo bonus The concrete was very smooth so it needed a bit of getting used to. I was jumping this thing soo high and landing on concrete really hard and it survived. I would rather this than a a big named brand No videos though, i will probably take it back there tomorrow so i will hopefully get some then, i dont have my pc so i wont be able to upload in a while Sent from my GT-S6500D using Tapatalk 2 |
|
Please Log in to join the conversation. |