TOPIC:

Easy for you😁 I love to see these conceptions.

Trimed the driver, put new tires on, change the rods that where too short... And it looks almost new






I still need to connect the motor, to paint the driver figure and add some some stckers and that will be done... But in the meantime, the project box is free, which means I'll be able to tear down two Hirobos

Fantastic revival.

It took about 6 months!
The motor is connected now, and I do not have any other car as silent as this one... Except that when I run it in the leaving room to check the trims, the dog is barking :-D



I still need to paint the driver figure. I intend to have this car ready for this season vintage events...

Top

Small step again... Really need to think how to make this driver figure...

Not sure yet about colours and decoration (yes I procrastinate )... But this is required anyway.

I did prepared the paint yesterday evening... But I just noticed that my black PS can was almost empty...


Today, once back from work, I decided to gamble on the fact that the can content was enough to do what I need and that was the case as the end... And the can is now really empty...

Few minutes later the paint is over...





I will perhaps add a few stickers, but I really like it this way...

There was something missing on this car...

Added lettering on the tires, but was still unhappy...


So I decided to  add leds, and I designed led holders... The side one is printed in TPU, the rear one in ABS (and it relies on the same principles I already used in the past)....




It's much better with leds... But somehow this is missing a wing...

Unsure about the wing. Maybe more side number plates  like the stadium cars.

Finishing touch...



Ready to run