I also saw it and thought "that's a Big Bear".
Is there any chance you could pop a picture up of a couple of parts? On mine the motor mount and the switch bracket that screws on the chassis between the rear mounts are missing. I have found a motor mount I can 3d print but would like to see one for real to compare them. Cheers Lee Regards
Lee |
|
Please Log in to join the conversation. |
|
Yes another tbird in france
The following user(s) Liked this: jord001
|
Please Log in to join the conversation. |
Sure, no problem at all I will take picture of the mount tomorrow
The following user(s) Liked this: jord001
|
|
Please Log in to join the conversation. |
|
First test with the dt03 and the ezrun combo. Perfect for me.
|
Please Log in to join the conversation. |
|
Attachments:
The following user(s) Liked this: jord001
|
Please Log in to join the conversation. |
|
Attachments:
The following user(s) Liked this: jord001
|
Please Log in to join the conversation.
Last edit: by stingray-63.
|
Today I'm messing with my Original Lunchbox Lunchy #1 Swapped the wheels over from Lunchy#2 just to have something to roll on. I've put new crystals in the tx and rx and I have movement on the servo's I just don't have power to the motor. It could be the connector so I will change that first. I think I have a spare. Then once its working I can start on the wheels. I will attempt to use the originals I got with it. Failing that I will buy a new set.
Regards
Lee
The following user(s) Liked this: stingray-63
|
|
Please Log in to join the conversation. |
Ok, so I worked out what the problem was. It was the connectors on the motor, they were a bit crusty. Cleaned them up and it worked. It's alive.
Here you can see the connector covers are still pulled down so I could clean them I dropped the original (now repaired) body on just to see how it looked and used the wheels off Lunchy#2 so I could have it running. Success!, now to sort out either using this shell or ordering a new one. I have to strip and prep this one anyway before I paint it. Found the original wheels in my box of wheels and they are pink, cant remember why, I think I used it as an undercoat for the Flourescent Red but changed my mind before I painted them red and brought the gold Monster Beetle wheels. Printing a motor mount for the CJ7 to see what its like. I'm hoping its the same as the Big Bear mount. Failing this I have a brushless motor mount for the Big Bear I can print and I will drill the holes to suit It should look like this when its finished. Then a fake air scoop for Lunchy #3 which goes in the top of the shell in place of the sun roof Lets see how it all comes out. Lee Regards
Lee Attachments:
The following user(s) Liked this: stingray-63
|
|
Please Log in to join the conversation. |
Regards
Lee Attachments:
The following user(s) Liked this: stingray-63
|
|
Please Log in to join the conversation. |
|
The RAM scoop with the mopar M is pretty.
The following user(s) Liked this: jord001
|
Please Log in to join the conversation. |