TOPIC:

Received the final test print of the HSII rear shock tower today Extra material caross the top to strengthen the weak spot  It will be avaliable through shapeways in about 3 weeks.


 

Really nice Andy. You will be able to run it in your next compétition. 

more historic accurate scale assesoires done

 

 

Today I grabbed my Hot Rod with me to enjoy the lovely weather.

It does climb 50 degree walls   (this is less)

Location for this picture is about 40km from me at the local mc trailclub training ground. Perfect for crawler, trail trucks 

impressive

Finished wiring up the KC lights for my new roll bar for my 86 Silverado 

15 minutes to trim a CLK-GTR Bodyshell, wheel arches included, clean and perfect cut. Never had found this so easy : you put the knife on your index, and you follow the cut line. This is really easy and the cut is perfect. Won't look back to over ways to trim a bodyshell. Trying means adopted.

Just ordered that knife.

I think that type of knife took off after Mechanics After Hours used one in one of his videos.
For those who have lived under the rocks lately, I highly recomend his YT channel.

My wife got one for years in her stuff... The blade wasn't that sharp, but the try was conclusive, and ordered new ones...
They exists in two versions : one with a free rotation blade and one with the usual blade... both works perfectly. I still have some doubts about the rotating blade in terms of precision, but i'm sure there is some use case where it will be useful.

I'll order one.