TOPIC:

Anyone know a good trick to flatten out the last thread?
Would be nice if that line is straight...
Thought about flipping around the dye for a turn or so but I don't think that'll do the job.

A parcel arrived from www.frost.co.uk - a James 8060 ultrasonic tank

It's quite well specified - a nominal 3 litre capacity, heater, drain, & timer up to 30 minutes. In practical terms, you can get at least twice as much in it as the Ultra 7000 model I had before, though it's still not going to be big enough to get a full chassis tub in there.

What it really needs is some sort of plug or fine filter on the drain hole to stop small bits escaping - I've ordered a couple of rubber bungs

Very nice... can you fax me a couple of parts, Jonny?

O.k. It's not exactly a tool,but definately tool related.I did'nt really need this but it was too damned nice to pass up!

Great stuff.

Nice

How much does it weigh? I have a steel unit & the only way that's going back down the stairs is if the floor collapses

It's not that bad(empty),made of aluminium and plastic and cost 795kr(£75) from Jula.se,the toy store for grown ups in Sweden.